b'PROGRAMMING THE SCREENLINE REMOTECONTROL (OPTION) The battery module is equipped as standard with a radio receiver for remote control. A 99-channel radio transmitting board is used for the remote control. The radio receiver housed in the battery module can memorize up to 26 channels; it can thus receive an equal number of addresses from one or several remote controls.Memorizing a channel1.Detach the battery module from its base plate;2.Select the required channel on the remote control display bypressing the +/- buttons; 3.Using a sharp tool, such as the end of a paperclip, press the programming button on the battery module (see image opposite) for 3 seconds, until the yellow LED on the up arrow turns on and immediately off;4.Within 20 seconds hook the battery module onto the base plateto be memorized;5. The yellow LED will remain steadily on and, within 10 seconds,it will be necessary to send the association command by pressing the up and down push buttons simultaneously on the remote control, until the green LED on the battery module flashes quickly.9'