b'Deleting a channel1.Detach the battery module from its base plate;2.Select the required channel on the remote control display bypressing the +/- buttons;3.Using a sharp tool, such as the end of a paperclip, pressthe programming button on the battery module (see image opposite) for 3 seconds, until the yellow LED on the up arrow turns on and immediately off;4.Within 20 seconds hook the battery module onto the base plateto be memorized;5.The yellow LED will remain steadily on and, within 10 seconds,it will be necessary to send the association command by pressing the up and down push buttons simultaneously on the remote control, until the green LED on the battery module flashes quickly.NOTE: the procedure can be suspended anytime by pressing again the programming button of the battery module. For further instructions on using the remote control, refer to the dedicated instruction manual.For further instructions on using the remote control, refer to the dedicated instruction manual.10'