b'MOVING FROM STANDARD OPERATING MODE TO TILTONLY MODE WITH BLIND SUPPLIED COMPLETELY RAISED AND VICE-VERSA1.Detach the battery module from its base plate;2.Press the programming button on the battery module for atleast 10 seconds. This will restart the device, as confirmed by a steady yellow LED on the up arrow;3.Release the button;4.Within 5 seconds from the release, press the programmingbutton once; the steady LED on the up arrow starts to flash quickly (if the button is not pressed again, the LED will turn off and the device will operate normally);5.Press the programming button once again; the LED on theup arrow turns off, and the LED on the down arrow turns on flashing;6.Within 10 seconds hook the battery module onto thebase plate;7.The base plate memory is written and the LED starts toflash slowly;8.After 10 seconds, the module starts to operate according tothe newly programmed mode.16'